Hey guys, thought I'd post this here also (I did post in the tech section but figured someone had the same issue as me).

I ordered the SAM system Shaker Motor for TWDLE and installed it. Once I went in the schematics to test the motor, it didn't go off. I followed the instructions 100%.

The Coil test for the shaker motor does not work (yes, we are holding the white coin door switch that sends High Voltage in the first place, but pressing Menu/black button does not give any activity on the motor.

My technician verified all the harnesses and there are no connection mistakes. He also used a 9Volt battery just to temporarily test the shaker motor and even at the reduced 9Volt, it spun fine.

Is there something to do in the sw setup (or newer firmware or something) that is needed before this motor can be activated? Else, I assume a defective PCB board/interface (SM PCB). We already checked the fuse and a few diodes and they are fine.

Any help would be appreciated!

Thanks!

Sure thing. Just took some pics now with the flash, got three photos. Here they are:

20171230_211546 (resized).jpg

20171230_211552 (resized).jpg

20171230_211624 (resized).jpg

Thanks for the suggestion. I'll double check how it's connected in the back. Cheers

Thanks for your help! I believe this is the culprit. I purchased this package from ebay and the first time I received the shaker motor, I received a REV C package instead of the REV B so the seller had to send me the correct package. Now I see that he also sent me the wrong PCB board.

Thanks for spotting that! I was sure my technician did everything 100% correct so this was becoming a riddle for us.

Cheers

It runs to the back box, but now I know I received the wrong part for the shaker. I'll need to contact the seller.