Quoted from firefighter:Get your Hard top set and then take a Sharpe and mark the holes that need to be reamed to make the holes work. Take it off the playfield and drill the holes. I have done two of these and always need to fine tune them a little. Great product and going to do Eight Ball Deluxe next.
I am still in the clear coating stage, but thinking ahead to alignment. Like pretty much everyone else, my alignment is probably 80% - 90% there. I was assuming that I would be putting the hardware back in the original spots but may need to cut out a bit of the hardtop if the edge of the hardtop covers the hole. Do I have this completely wrong? Am I supposed to be drilling new holes in the center of the hardtop cut out? If so, what happens to the holes that have a T-Nut on the back?
Now I am getting worried that I am thinking about this all wrong.