Hi all.

After having some issues with resets on my JD I reflowed some solder joints on the power driver board for J101-3, fuse 113 and the LM323K regulator.

Now the resets have stopped but I am reading 5.75 volts at TP2. Out of interest, I tested the TP2 voltage on my DM. It is also high at 5.75.

The rest of my games are at 5 or below, as is normal.

Are these voltages too high? Will they cause any damage? If so, where should I look to rectify? The boards are clean with no hacks. The games play fine otherwise.

I checked the voltages again today and they were at 5.38. Still a bit high, but better. The connection to the regulator case and ground is good - only 0.05 ohm resistance. No resistors anywhere they shouldn't be.

I think I will leave it be for now. 5.38 is better than 5.7.