Happy Sunday,
The sound on my new Whirlwind is still a bit high for home use, even though the pot is all the way down. The pot works otherwise (It crackles a bit but it adjusts the volume louder without a problem)
After doing some research, I stumbled on a thread that recommended removing the resistor on the volume pot. Tried that & the sound become even louder and practically maxed out.
Just looking for a little guidance here. Should I start testing chips next? Should I try jumping the resistor instead? Is there something in the settings I'm missing? I just replaced the batteries, but could it be a cold solder joint on the holder? I did receive an "adjust failure" message when I fired it up for the first time, but it has since gone away after re-inserting the batteries...
Thank you in advance!