Lights Kit for your figurine MechaGodzilla on Premium or LE machine.

This kit is done with a special bulb to connect the wiring, the wiring, a special connector made in resin to connect the optical fiber and the yellow led to do the lights.

For the lights possible colors for the eyes : purple, pink, blue, red, green, white, orange, yellow.

Send us a message to choose your color.

Warning : it is on your responsibility to drill two holes in your figurine to make lights in it !

Installation : Before any manipulation, you have to uninstall your figurine from your playfield. If you have some doubt about how to do it, ask me.
Once this phase done,

First, you have to drill the eyes in the center with a small metallic drill at 1 mm of diameter to be sure you are at the center of each eye. You should drill at an angle that makes your drill bit angled towards your figure's feet. After you take a 3 mm drill and when you succeed to make the hole, you can pass one side of the optical fiber (fiber I give is Ok to push from the eye to inside the body). You take the other side of the optical fiber and you pass the fiber in the other eye. So in the body you have two fibers. You connect the two fibers to the special connector we have made for this kit and you add the led on the other side of the connector. Normally the led is already connected to the special connector in the parcel you received. You push the connector and the fiber in the deep in the head of figurine. You can pull on the fiber on the other side. After you cut the fiber at the level of the eyes and you adjust the fiber on the eyes. You have to install again your figurine in your playfield and you have to connect the specific bulb we give under the plastic. The diameter of the fiber is 3 mm. I hope it is clear for you and this procedure helps you. If you have some other question, don’t hesitate to ask me !

Enjoy your MechaGodzilla !