On my T2, the right flipper fuse blew. It turns out one of the diodes was bad. I replaced the diode and now the flipper works, but gets stuck in the up position if it is engaged for more than a quick flip. Also, the right flipper will jump a little in attract mode if I hit the button.

I was thinking maybe a transistor is bad but I can't figure out which one it is. Anyone have a problem like this or have some ideas?

Thanks!

EOS switch is good. Diodes are correct though I couldn't get them through that little hole on the center lug. Maybe I should replace the coil?

I'm still thinking the bad diode might have jacked up something on the board. Is that possible?

After looking at Vid's rebuild guide, I see that my High Speed coils are upside down (lugs against the coil stop).

Did it in the machine.