Started working on a non-working Space Station I just bought. boards look clean as far as acid-burnt pins or connectors, or prior work being done. only a couple cracked solder pins. I did have to remove the small relay boards under playfield to re-solder pins to get my playfield gi back on. I have it to the point where it works to play a game but most of the solenoids are not working. The ones that are working are- out hole-pop bumpers-single drop target in front of ramp-left center kick out-that is it. The ones that are not working are -kickers (slings), drop targets, kick back, upper right and upper center kick ups. this is a lot things not working. At first I thought it might be the special solenoids -because I thought just the upper kick outs and slings were not working. Then I saw the other problems. I have re-soldered any cracked edge connector pins. Any ideas?