Hello Pinside, my latest project is bringing back a very dead High Speed. I finally got it to boot up, got three of the four displays to work and even saw some attract mode, but I can't fully access the menus because one of the diagnostic switches on the coin door has its wires broken off and it looks like it has been monkeyed with before because there are quite a few pins on that switch that show evidence of solder. I'm referring to the switch FURTHEST from the hinge on the 3 switch test panel. Mine has a diode attached to one of the now loose wires. Can someone please snap a close up picture of their wiring?

Very much obliged. I was quite frustrated last night, couldn't set free play and the coin slot switches wouldn't add credits! After all the work I've put in to this I JUST WANT TO PLAY IT!

Thanks,
Art.

Thank you, sir! that would be very much appreciated!
Art.

Hey Whridlsoncestood, nevermind, I just found a nice clear picture online. Thanks for the offer!
Art.