Just wondering to those out there who have done ramp mods to their Tron already, whats the best method of planning the drill holes on the ramps? Im going every six inches or so, but I want to make sure they are tight and hugging the curves. So it doesn't look sloppy. Anything you would have done differently?

Iv got the method set. Iv used the soldering iron before and find the holes 'cleaner' when you drill. I guess Im more wondering about hole placement? How to keep the wire tight and anything you would do over if you could. You only get 1 shot after all.

I had started but held off on the drilling more till I got some responses. Thanks for all of this. It seems I have so far drilled LESS holes than Martin's guide but around the same as the LE. (and Kimball's I think is the LE too?)

I'll watch B_R's video and maybe pick up some scotch tape (thought about doing that already but had none in the house. My instincts were to use as little zip ties as possible for a clean look. Maybe there is a happy medium between tape and less holes?