Chicago, IL
Lock is out of adjustment:
Remove arm loosen 7/8 nut a few turns until tooth washer can be backed out to adjust.
(Topic ID: 345493)
You're currently viewing posts by Pinsider PINTEC.
Click here to go back to viewing the entire thread.
Quoted from TheBananaPeel69:what should it look like at rest?
Turn the key to lock remove key.
Rotate the lock cylinder while loosened just until the bar's second tab is over where the top of glass would be.
Mark the location of the cylinder.
Re tighten 7/8 cylinder nut and re install linkage.
Check and re adjust as needed until the cylinder unlocks and clears the track and that in locked position key can be removed
You're currently viewing posts by Pinsider PINTEC.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
