Are you tired of your flippers feeling a little more Jerry than Rick? Well NinjaCamp has you covered! Applying this simple fix will get your flippers rock hard in no time at all. Instead of messing with your flipper bushings, this solution allows you to simply lower the flipper mech without removing/re-aligning the flippers. Printed out of premium Prusament PETG, you will receive a set of three Xspacers along with all of the 5/8ths screws needed to fully swap out your existing mech screws. The entire process takes about 40 minutes and results in flipper performance never before seen by factory delivered Rick and Morty machines. Color will be yellow or orange depending on material in stock.