Any Rush fan will immediately recognize the significance of a rabbit in a hat, as a reference to the Presto album cover!

I noticed there were several of the chunky red flasher domes in the game layout, and also noticed the one in the lower right corner could use some dressing up.
Using some existing models that I modified, paired together, 3D-printed, then added some post-print touchups, I present Rocket City Pinball's Presto mod!

I print the rabbit in translucent white/clear so it lights up when the flasher fires or pulses. The appearance is challenging to capture in photos, so please see the video below for a better look. The hat has a lobe to attach at one of the existing holes from the flasher cover. The hat is printed in black. After printing & cleanup of the support edges under the brim, I paint the top surface of the brim in a matte black paint to make the layer lines more subtle. I also add details to the rabbit in ink, for the ears, eyes, and nose/mouth.

The installation process is fairly obvious, so I did not produce a DIY video -- simply remove the screws/washers/nuts on the existing flasher cover and flasher, remove the flasher cover, reinstall the flasher board & screw/washer/nut at the back hole, and attach the hat with the screw/washer/nut at the front hole.

This mod will also fit at the flashers on the slingshots, or the flasher in the back-right corner by the S-curve in the ramp (though I recommend you put my Signals mod there! See link below)