JD Towers GREEN V2* and JD Towers RED V2* are now available. This set of Three CoolingTowers is 3D printed , assembled, masked ,primed, airbrushed, hand painted, and wired together. Each tower has an LED bulb and socket and is wired to the next tower. I used matrix connectors and the JD Towers connect to the GI bulb socket on the playfield below the plastic for the captive balls. To install, first remove the old plastic stand-up cooling towers, you will need to drill out the rivets that hold them in place. Then enlarge one specific hole left over from the removal of the stand-ups. Through that hole, you will push the matrix connector through the plastic to make connection to the playfield GI bulb socket. Matrix connectors, and matrix bulb socket power connector included. Hooking this up to the GI of the playfield will give you constantly lit JD Cooling Towers.

You can also hook these up for Meltdown mode specific lighting, they will light only during the Meltdown mode if hooked up to the flashing "Meltdown" insert light , however I will need to change the bulbs out to incandescent.

Towers come standard with LEDs. Each tower comes with a small adhesive strip for attachment to the playfield plastic.

There is also one more variation for Green and Red JD Towers: Glowing Cracks! see photos

*V2 has the tower numbers printed separately and assembled after painting and the wiring conduit that connects the towers together has been made more robust.