Hook pinball machine. We just picked this one up, but it has several problems that need to be addressed, and we are not willing to put any more money or time into it.

The bad:

- DMD is out gassing. It takes a while for it to warm up to the point where all lines are visible.
- Sound board is rebooting frequently. I suspect it’s a power supply problem as it looks like there is some suspect repair work that has been done in the past.
- Interlock switch on the coin door is not working, so high voltage to the coils is not being disabled as it should when coin door is opened.
- lockdown bar receiver is bent and should probably be replaced
- shooter assembly is missing an oilite bushing
- cabinet is a bit beat up. The bottoms of the sides specifically have some spots where the plywood is delaminating.
- someone cut one of the wires to the knocker coil, and the knocker is not working
- the lockdown bar and legs have been poorly spray painted over the original worn powder coating
- there’s holes in the front from a security bar that was probably over the coin door at some point
- the lock for the translite isn’t currently installed as the previous owner didn’t have the key
- some broken plastics
- low quality inner art blades which are ripping
- there may be other issues as well that we haven’t found yet.

The good:
- NVRAM installed, and I don’t see any battery corrosion on the MPU board
- LEDs throughout
- Playfield itself is in decent shape with minimal wear
- it comes with the latest 5.01 unofficial code from 2018
- flippers seem strong

At a minimum this probably needs a new DMD, a new power supply and a new lockdown bar receiver. This is located in our basement, down a flight of stairs