Clean and good condition. Everything works, including revolving topper light and coin mechs. Super fun machine. Backglass close to perfect. Installed clear ramp mod in Feb 2017. At that time I cleaned and waxed the playfield and replaced all rubbers and most of the bulbs on the machine. Flippers rebuilt in Fall of 2018. Inkochnito board installed in March 2018. Remote battery holder, and no battery corrosion on the board. Original "Hot Action Pinball" topper, manual, and original black plastic ramp included. The black ramp was cracked, which is what prompted me to install the new clear ramp. The person who made the clear ramp also repaired the original ramp for me, so it will work fine if you want to switch it back.

EDIT Jan 1, 2019: After receiving some questions about condition, I've gone back and looked carefully at the playfield, and I'd like to include some more "cons" for prospective buyers. Some of these items can be seen in the photos.

-There is a thin strip of wear in the left outlane
-There is wear on both left and right inlanes, where it says "LIGHTS FREEWAY"
-There is a thin strip of wear about 1.5" long just past the gate at the end of the plunger lane
-The DRIVE 55 AND STAY ALIVE plastic has breaks at two mounting holes; one is reinforced with wire
-The plastic on the other side of the ramp opening has a break at the mounting hole farthest from the player
-The plastic in front of the pop-bumper closest to the player has a break at one mounting hole
-The plastic with the Oil Pressure gauge has a noticeable scratch
-The cap on the pop-bumper closest to the player appears to have a bit of edge broken off; hard to describe this. It's very hard to notice if you're not looking very carefully.
-The "San Diego Freeway" and "Santa Monica Freeway" spinner stickers are beat up (I believe repros are available)

Also: The stoplight (which works perfectly) was relocated to the left rear corner of the playfield as part of the clear-ramp mod. An auxiliary molex-ended wiring harness was included with the ramp which allows the light to be relocated without having to damage the original wiring harness. A small notch was cut into the wood at the rear of the playfield cabinet to allow the wire to pass through.

Also: There is wear on the outer cabinet itself but I think that should all be pretty plain in the photos.

This machine is in my clean, non-smoking basement. It will require me to remove the backbox and legs before it can be brought up to the first floor. If you put a deposit on the machine, I can have it brought upstairs, re-assembled, and tested before you arrive to pick it up. If you'd rather see the machine in person first, budget a little extra time for me to remove the backbox and legs, and you will need to help me get it up the steps. Once it's upstairs, I'll be happy to re-attach the backbox so you can give it a final test.

EDIT Jan 2, 2019: Coin box is not shown in photos but it is included.