Williams Bram Stoker's Dracula

Machine is in nice condition, beautiful playfield, plays 100% error free. This BSD has the more desirable SP playfield with no planking.

The following has been done:

Machine shopped with a new rubbers, bulbs replace with all LEDs. All ramps taken out and cleaned. All Flashers are LEDs as well.

New Mylar placed at all the heavy ball traffic locations.

Cliffy Protectors on the kickout holes and roll over switch where ball drops.

ColorDMD LED version. (If buyer wishes for the LCD version, I can switch from my other machine)

Clear Speaker Installed for ColorDMD

Pinsound Plus board (New version)

Pinsound Headphones Jack Station.

New Williams Black legs.

Plastic Protectors on the slings, center standup targets.

Promo Slingshot shot plastics installed.

Remote Battery Holder installed.

New upgraded bacbox 5.25" speakers installed.

New upgraded cabinet 6.5" subwoofer installed.

Wolf figured added ( I mean why not )

New 24" Opto Board installed

New opto's installed on the 24" beam.

Spare complete plastic kit included.

Tilt Graphics side blades not installed yet but included.

New Williams side rails included not installed yet. (I'll get back to this in a sec)

10' remote usb 3.0 cable installed for Pinsound board.

Thumb drive with 3 pinsound packages installed included.

Set of Hard plastic Red Leg Protectors included, with soft felt pads as well.

Fresh sheet of Glass NIB

Lower cab looks real nice and the red color is present and vibrant.



** Please note I was asked about the thin visible white lines seen in some of the photos in front of the kickout holes, targets and ramps. That is mylar to protect those high traffic ball areas, not cuts in the playfield. **

Now the negatives that I see:

Some small chips in the head corner, don't see it in a lineup but I was going to re do them anyway.

Some genius removed the barcode off the playfield, I had since created a new one and placed it then mylar over it. Not really noticeable but I want to disclose that it case the buyer didn't see it off the bat. Barcode photo is shown in the photos.

Side rails have the usual dents from the head. Head not damaged but rails were so there is a new set included that wasn't installed yet as I was going to do them and the sideblades at the same time.

Usual decal wrinkling at the leg area, but covered with leg protectors.


That's all I can think of, any questions please feel free to contact me.

Game located in Staten Island NY, prefer cash sale.

Asking $5700.00 / OBO within reason. Looking to get what I have into it.

Short Video Preview:
https://youtube.com/shorts/Ybdh_haC71U?feature=share


Thanks