Just got it back together...I plays nicely but still needs to be dialed in and I just do not have the drive to spend the time on it. I have a flipper rebuild kit for it that I will attempt to get to while it is still in my posession. It is fully LED except for flashers. I installed Cliffys and have a plastic protector kit that needs installed. New rubbers have been installed. The boards have been serviced by an experienced board repair person (Jerry Clause) and NVRAM installed. There is minimal wear around the fish which is the typical spot and two if the sticker decals are coming up a bit. All plastics are complete and in fine condition...no breaks and I even replaced a few with new. Cab is faded and front corner has separated...it pushes together nice but I do not have the right size clamps to hold it for glueing. All the hard expensive stuff has been done For a nice game, just needs someone to take it over the finish line

Thanks!