Quoted from MT45:
Another simple question for you long time owners. My spinning disc is flaking pieces all over the playfield. I have a new replacement decal for it in hand.
How do you remove the old one? Plastic razor blade and elbow grease?
How do you clean any left over residue? Goo gone?
Tips on laying down the new one?
Thought I'd share what I discovered:
- Pretty simple to grab an edge of the old decal with a razor blade
- Start peeling in direction around the perimeter
- If the top layer comes off first, just grab the base layer (which is 3M 2 faced tape)
- Go slow and you pull most of the sticky residue with it
- Use a plastic razor to get the rest, then goo-gone
Adding new:
- First, pop out all the slots (these correspond to the slots that show the red/blue lights below the disc) using a pick
- These are not punched out but they are die cut
- Carefully align because you don't get a second shot
- The light reveal slots in the decal from Marco don't quite line up
- Get one side right, get it stuck down, then razor knife out the slots on the opposite side
- Use a pick to pull up the razored slivers and they will simply pull off
IMG_6263 (resized).JPGIMG_6265 (resized).JPGIMG_6267 (resized).JPGIMG_6271 (resized).JPG