Updated the code and played a couple of quick games. Noticed that the scoop works fine, but having an issue with it not ejecting after starting a villain. It has to go to ball search to kick it out.

Played a bit more. It makes good contact, just intermittent. I will add one to my next parts order. Thanks!

I have been working away on our X-Men Pro. It now has Comet bulbs through out. I flame polished the ramps. We put in clear Titan rings everywhere except for blue on the new yellow flippers. I have a few things left to do: wolverine magnet core, scoop switch, and straighten the standup targets by magneto.

The pic was taken in the dark both times. What a difference the bulbs make.

20200415_002900.jpg

No light strips in there. The spots are on the slings which were there when I bought it. Not sure if they are stock or not. I put in the 4 SMD bulbs there. There is also the spotlight behind wolverine, but that one is controlled right? Otherwise, its all 2SMD comet bulbs everywhere. The clear rings help a bunch in getting the light spread out in my opinion.

I did run a small comet led strip to put on the back of the head. Its not visible at all in my garage. It should look good once I get it in the game room though. I put one on Stranger Things and Jurassic Park and like the look. I used Orange for X-men. The red in this pic on MMr is from the topper.

20200329_185009 (resized).jpg

Ok a few more things done. May be able to call it "done" now, or as done as can be with pinball (never). I will play test a bit to see if anything else pops up.

Replaced the mushroomed wolverine magnet core and put a mylar ring down
Straightened up the lock targets
Replaced the scoop switch/diode
Made a gate for the lock shot under magneto (was missing)

20200416_124924.jpg

20200416_163744.jpg

20200416_164153.jpg

Yep pretty sure that is a flasher not a 6v gi socket. 12v makes sense.