Quoted from Spatacuulous:So all the screws are tight and I took a look in the settings even though I was never in there before and everything looks good to me. I played today and it’s still doing the same thing. Will not send balls up into the wonkavator because they are not diverted to begin with. I tested the diverter coil manually and it works just fine as does the VUK. Anyone have any suggestions? Any help is greatly appreciated.
Thanks - Frank[quoted image]
Its using virtual locks because something is out of wack. It was a series of problems of this machine.
The green squares mean a ball is on that position. In the pic shared, were any pinballs in the first lock and the VUK lock? Is the green lock light on the Wonkavator on (on the playfield would be the bottom one)?
Bet an opto on the far left fell off. See pics. Notice the small black half circle with two wires on the long end? Used electrical tape to hold it up.
Start there and report.
8287BFA0-9858-49AB-A86D-BCDE3E264E13 (resized).jpegC68C9B20-14FD-4AED-AE6A-82F77D3EED3F (resized).jpeg