(Topic ID: 240130)
Linked Games
Willy Wonka & The Chocolate Factory (CE)
Jersey Jack, 2019-
Willy Wonka & The Chocolate Factory (LE)
Jersey Jack, 2019
-
Willy Wonka & The Chocolate Factory (Standard)
Jersey Jack, 2019
Topic Gallery
You're currently viewing posts by Pinsider Sunsfan23.
Click here to go back to viewing the entire thread.
Kennewick, WA
1 week later
2 weeks later
1 week later
Quoted from paulbaptiste:This game would definitely benefit from pinstadiums. I've seen the before and after pictures and its remarkable. Before I added spotlights I had to have an office lamp right above the game to see while playing.
I purchased 12v bulbs and spotlights from Comet pinball and JJP power tap from mezel mods.
I have a few of these for all my JJP games to power any lights or mods I may add.[quoted image]
Awesome thanks!
Got some pinstadiums on order
1 month later
2 weeks later
3 weeks later
On the factory ramp to the left the metal bar that comes down to stop the ball will only intermittently drop to the left upper flipper correct? Or should it drop it down every time?
I’m getting a mix of both and it doesn’t seem to make much sense. I’ve even had the lower flipper flip twice as if to signal the ball was going to be dropped and it did not and was released to go down the metal rails back to the normal left flipper.
Quoted from LTG:Is the coil loose ? ( screw for it is under the wireform )
LTG : )
I will check and get back with you. Thanks!
2 months later
4 months later
Quoted from naf_llabnip:Fact: the JJP camera adds roughly 20 pounds and 20 years. Only explanation I have for the horrible photos of some grumpy looking old man that keeps getting high scores on my machine.
Hahaha!!
1 week later
Having issues with the gobstopper switch getting stuck. Tried bending the switch a little tighter but it still not flexing enough to activate the switch. Tried tightening the spring a bit too with no resolution. Any ideas?
601AA002-3184-4E47-90C6-47BC24DFC193 (resized).jpeg7FB79912-E79C-4E28-948D-5ED4BEBE38A9 (resized).jpeg9F247A74-4CAA-4FA5-82DC-A52249DF0299 (resized).jpegQuoted from Pinballomatic:Remember that the switch is normally closed and hitting the shield target makes it open briefly then the springs pull back and hold it closed again. It’s the opposite of most microswitches.
Yes it’s currently not registering with it closed either
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider Sunsfan23.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
