Fuse F115 on the powerdriver
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Quoted from Pesmerga:where should i hook the probe
You can use C31 to hook up the probe. Left leg= (+5V), right = GND
Then with the probe on U25-1 and -14.
Quoted from Pesmerga:Resistors r111 and r113 are both low
When resistors R111 & R113 are LOW on both sides, they are not connected to the 5V. (damaged trace ?)
When they are LOW on one side and HIGH on other, U25 is most likely the culprit. Note that U25 pin 6 and 8 must be HIGH (5v) at all times.
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/wpc95-mpu-cause-flipper-stuck-on?tu=zaza and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.