Getaway: High Speed II, The
Williams, 1992You're currently viewing posts by Pinsider sparky70.
Click here to go back to viewing the entire thread.
Coincidently, I am currently having the same problem on my HSII.
Would it be too confusing for me to jump in on this thread, or should I start another?
When pressing start button during single lamp test, info says the pins are 134 pin 9 (red/grey) and 137 pin 6 (yellow/blue) although my red/grey is at 135 pin 9 and yellow/blue is at 138 pin 6.
I believe this is OK. Am I correct?
I also see that the red wire passes through the coin board. Thanks. Sparky
Wow zaza, that's a great pic, that really narrows it down visually. Did you make the diagram?
My bulb is good,
Socket is good,
I tested my diode d1 on the board, it tested out of spec. So my dumb question is, can I jump past the diode to confirm the diode is bad without harm?
Thanks. Sparky
You're currently viewing posts by Pinsider sparky70.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/wpc-start-button-light-does-not-work-hs-ii?tu=sparky70 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Mesa, AZ