Verify that the red line on the ribbon-cable is on pin1 at CPU-J204 and pin1 at 8DRV-J1.
Does switch-matrix column9 work ? test it in testmenu T.14 and T.15 -mark & home switches.
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Verify that the red line on the ribbon-cable is on pin1 at CPU-J204 and pin1 at 8DRV-J1.
Does switch-matrix column9 work ? test it in testmenu T.14 and T.15 -mark & home switches.
Quoted from pinballholder:I ran T.14 and it shows two closed switches. I ran T.15 and it shows one open switch and one closed switch.
Quoted from pinballholder:I tested all 8 that were on the Aux Driver board (four are for the flashers and the four for the solenoids that are not working)
No, and that is why I asked to test the switches in T.14 and T.15.
Column 9 is generated at this board and it seems to work.
I circled in next picture all components in GREEN that are working since you have a working column 9.
That is 5Volt, 12Volt, Digital ground, ribbon cable correct, etc.
I circled in BLUE the connection that has not been verified, being Power-GND
so, check PowerdriverBoard J103. Is GND connected here and making continuity all the way to 8DRV-board ?
sttng_connct_8_drv_(resized).jpg
You're currently viewing posts by Pinsider zaza.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/wpc-star-trek-tng-coils-not-firing?tu=zaza and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.