Here is what the CPU is configured as:
W3 in
W4 in
W7 in
R93 out
Getting Vbatt at RAM pins 27 and 28, but not 26.
Should R93 be installed?
You're currently viewing posts by Pinsider adalogue.
Click here to go back to viewing the entire thread.
Here is what the CPU is configured as:
W3 in
W4 in
W7 in
R93 out
Getting Vbatt at RAM pins 27 and 28, but not 26.
Should R93 be installed?
256k RAM cutsheet says pin 26 is an addressing line, so no Vbatt goes there, although repair guides indicate it should. If Vbatt is getting to pin 28 on the RAM, why in the world would I be losing settings? Time and date stay correct, but adjustments reset. I've already replaced the RAM once and installed a socket.
Help!
Ok, so current jumper config and R93 not being there is correct for the 256k RAM. I'll try re-seating the ASIC chip and see if that helps, thanks!
You're currently viewing posts by Pinsider adalogue.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/wpc-factory-settings-restored-r93?tu=adalogue and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.