Had not played my YBR WOZ in a while and I keep it unplugged when not in use but when I plugged it in and turned on the power switch on the front right side - the “no signal” came up on the 27” screen for a few seconds snd then the screen goes black not wanting to boot up like normal. I checked the support vids on JJP and did the jumper process but still nothing. I replaced the coin style 2032 battery thinking it might have died but still nothing. All 3 fans are spinning but still nothing. I read there is a button somewhere located in the back box but I have not found. Here are some pics so I can get the about location where this button is. I have placed an email to JJP so we can figure it out. Still have warranty.

41CDA035-5510-49EF-BA15-82BACBFB27AB (resized).jpeg

D4FE7F38-D42D-41B0-B19B-D4FD2C0E11E9 (resized).jpeg

EDB3FAE9-62B4-4790-AEB4-79D89AEF4DC3 (resized).jpeg

FEED482A-F471-4A7D-88F1-8E59696D89B3 (resized).jpeg

So no button and the only other thing is to do the jumper method which I have done several times and nothing happens- hmmmmm

So connect the two in the red box together (reset) and if that does not work, connect to two in the green box (pw)

FA2A91F6-5626-44B8-912E-6DA8ED0B9D3D (resized).jpeg

Tried touching them both and nada. Still the little no sig comes up and that’s it screen black. I was touching the 2 while the pin was powered up and only touching them for a few seconds on each set
Thanks for the help but I think it will be left up to the experts from JJP.

Tried to re-seat all cables and still this no signal problem. Anyone have any ideas? Should I buy another hdmi to DVI 18/1 cable?

A240F933-419E-4BE6-B5BD-DFC5D9FA78CC (resized).jpeg

I will just get a new cable and have JJP send me a new video card, mother board and just go one at a time till it’s fixed lol - I have an appt on Friday morning with Ken to figure this out.

Replacing the mother board - JJP is sending it out

We are back in business- JJP customer service is A #1

F8C07176-BC19-4742-B594-727F905EF165 (resized).jpeg