Working on a small mod that is a light behind the lane guide plastic. Just a small bar of light that sits behind the plastic and gives a bit of lighting to an otherwise dark/hard to read sign. I used some thick paper to make the box to keep the lighting contained. Ideally it'd be a plastic box that sort of clips on to the plastic. It's a 3 LED strip that, when too close to the plastic, doesn't illuminate it all the way so the paper keeps it away far enough to light it all up. Would really like to angle the container a bit to "project" the light a bit giving it a chance to diffuse and look more blended in. For a few minutes and a few bucks I think it's looking pretty good. I don't have a 3D printer or access to much stuff to create this kind of thing, just basic tools. Going to try and fit it around the green LEDs that are there so it broadcasts the light a bit higher on the sign. Looks better in person, not such a harsh line of light.
1231181430b (resized).jpg1231181430c (resized).jpg1231181431 (resized).jpg