OP

Quoted from nostra:

Hey,
Im pretty new to the forum (hello!) so sorry for stupid questions... I just bought a ECE WoZ and there are some minor issues that I have no clue how to fix.
I updated it to code 6.x and since then I have some problems. I guess the pre-owner adjusted some things in the settings that were put back to standard now.
Crystal Ball:
Crystal ball shoots (to) hard. The ball flips out of the green rails - sometime even hits the glass.
Shall I adjust this via settings or on the playfield?
Shooting lane:
After shooting the ball so that it gets out of the lane "below" the house/twister playfield the ball gets stuck. After some shaking the ball comes back
Drop target to Castle:
If drop target is down and the ball gets behind it (not shot hard enough to get up to the castle) it gets stuck (behind the drop target that is down).
Shaking helps sometimes
Castle loop:
The switch in the castle loop stays down sometimes causing error. Its not coming back up (error 71). I tried soft bending which helped a little.. but not as fix
THANKS!!

OP

Quoted from nostra:

Wow! Thanks for the help. I was able to fix all the issues.
After playing another issue occurred
Playing like an hour almost all lights are on - and stay on. Except for the upper part of the playfield between the two mini playfields (castle, twister).
The lights stay on/solid all the time... even if I start a new game. After rebooting the machine all of the lights that were solid/on are then off.
Only the lights that were working before (between the playfields) are working as expected.
If I let the pinball rest for some time (overnight f.exp.) everything is back to normal. After some playing it happens again from time to time.
I already got the 7.5V boards.
In the screenshot I attached below you can see the situation after reboot. All lights were solid (except upper ones), rebooted, went into menu and did a all lights on test. Only the upper ones react. Rest is dark.
Is this a known issue? Any way to debug?
Thx again!!
[quoted image]