I just completed the conversion as a preventive measure because everyone said to do so. Havng said that I have a complete set of 7.5 Rev 1.1 boards that were working perfectly for sale if anyone is interested. Also have all wiring is anyone is in need of a replacement.

20221123_053659 (resized).jpg

The GI is less bright but honestly on this game it doesnt make a difference truly. There is so much pop from the RGB system. As to when you do it, I think its personal preference. I just finished it and I took about 3 days off and on. ( did have to wait on some things not in box- fish paper) Just meticulously follow directions and youll get there. I did mine preventively as I had no probem with the 7.5 buffered system.

Well I didnt cut wires, I saved all and sold everything as a package. So first day I removed all large boards and wires and the individual leds. Had to wait on some fish paper since i only got 4 pieces ( could have used electrical tape but has other things to do). Replaced each large board as I removed, used the map or wires and guides to position new single led boards, used the dimple tootl and drill holes and mounted. Going in ordeer as I removed and labeling new boards with sharpie.

Second day was removing and replacing boards in castle playfield and munchkinland. Not hard, take your time and dont force anything. Hardest part was getting all the new wiring down the holes while lowering playfield and not trapping anything underneath. The raindow board is the worst. They do send new plastic rivets but do not send new rubber push through washers that attach the board to the plastic with the black filter sandwiched in between. Would have some of those on hand before you try.

Third day fish paper arrived, finished the single led boards that require that and the ran started running rgb cabling. The cables look very similar and the inventory drawing is a small picture and hard to tell. Follow the diagram to see how many leds are connected to each string and count the connectors on the strings and you can figure it out. ( Would be nice if they were numbered).

Last are the Cat 5 cable and they are simple. The directions are pretty good. Would add that when you get to the step of removing the toto lane and haunted house cable, it says to leave the cable in machine as this will be used. This isnt that clear, but you will need tomake sure you have some play to be able to run cable to the WOZ7 board in the lower left corner ( playfield upright).

I would say total hours was 12-15.

They proactively changed my bag board out once I received my kit so they may have missed you. LTG is right they were some that went out unrogrammed from the factory.

i got mine about 3 months ago and just got around to installing

a simple reboot without anything else fixed your issue?

Anyone with A Steve Gouveia witch mod still have instructions? I was able to snag one and need some guidance. Thanks

the one on youtube isnt for gouveias that i saw. but maybe i didnt see the right one. Also Hippy did you add the lermods LED strip to yours and if so where does that go

Thats great- just snap appic if you would and shoot it to me

lermods sent me the install. will look up the video you suggested

Thanks for the help- got it in and working. Now if I can locate a flying monkey

Just go step by step and remove the wires intact also- cleaner install. I sold mine with the boards and they may come in handy for some. Take your time and youll be fine.

did the show completely break or just come off the bat?

Is thereby chance a jumper on the mainboard marked pwd? Any documentation with the board? Sometimes there is a jumper to either require or not require a pwd.

Oh wait thats right this is your same board, you only changed PS. I would take board out and try on PC and see if you get a pwd prompt there. This one is getting wierd.

Can you take a screenshot of whats happeniing both in pc and in machine so we can see?