I was asked to post a couple photos of how i attached a couple of my hallmark ornaments.
The Coroner is attached to a piece of shaped plastic that is then attached to the game plastic. Overkill. No reason for this but I had some grand idea apparently. 20210126_183135 (Large) (resized).jpg
The Mayor is attached to a piece of acrylic that I heated and shaped and then double side taped it to the little metal piece that was in the game already. He barely clears the munchkinland outhole.20210126_183106 (Large) (resized).jpg
The Winkie Guard is attached using a piece of 14g house wire. 12g preferred for a sturdier fit but it will work fine. Wanted coating on the wire and had black as well as white and green on a roll of 14-3 purchased a while ago. No idea why I stripped the one side, there was no reason for it.
Honestly didn't think I'd get it to sit right on the first shot but once it was in it fit so well I left it. It tucks in nicely by that nut at the end of his staff and the castle wall indentation. Drilled a small hole just under his waist line basically. Its some type of resin cast so it won't crack easily.20210126_183549 (Large) (resized).jpg
Dorothy is attached to a screw with green wire the same way. I had some silicone washers so i put them on. Overkill again but i'm not removing them. This was the first one I put on a month or so ago. She shakes a bit when the shaker goes off and stuff but so far there's no worry about it losing its shape or position.20210126_183513 (Large) (resized).jpg
Hope that helps.
r/
Mike