(Topic ID: 139243)

WOZ Castle VUK Habitrail


By MT45

4 years ago



Topic Stats

  • 8 posts
  • 5 Pinsiders participating
  • Latest reply 4 years ago by MT45
  • No one calls this topic a favorite

You

Linked Games

Topic Gallery

There have been 5 images uploaded to this topic. (View topic image gallery).

2015-09-18_22.48.20.jpg
image.jpg
IMG_8197.jpg
20150918_204140.jpg
20150918_204208.jpg

#1 4 years ago

Wondering if anyone has or would take a picture for me looking square down at the castle VUK habitrail? Mine seems to be very close to the edge of the castle PF and although the ball does not hang up there, it does tap the wall on the wall down. Does yours? I tried everything short of bending it. Wondering if a nylon spacer placed under the right habitrail post would help to "tip" it toward the correct orientation?20150918_204208.jpg20150918_204140.jpg

#2 4 years ago

I'd try a nylon spacer.

LTG : )

#3 4 years ago

Yeah, mine doesn't hit the side wall.

IMG_8197.jpg

#4 4 years ago

Mine has been fine.image.jpg

#5 4 years ago

My edge is flush to wall. Hope any of this helps.

#6 4 years ago

The right nut has it on post and the left has more room. I think you could loosen the two and shift the whole thing to your left a little. That left nut is a little tough to get to. Use a box end wrench.

#7 4 years ago

When I had my 75th, mine looked similar to yours. I adjusted it out the best I can, but I think it still hit the wall a little. Either way it dropped. It was a pain though.

Quoted from MT45:

Wondering if anyone has or would take a picture for me looking square down at the castle VUK habitrail? Mine seems to be very close to the edge of the castle PF and although the ball does not hang up there, it does tap the wall on the wall down. Does yours? I tried everything short of bending it. Wondering if a nylon spacer placed under the right habitrail post would help to "tip" it toward the correct orientation?

#8 4 years ago
Quoted from LTG:

I'd try a nylon spacer.
LTG : )

Thx Lloyd - and I did add a spacer. It's circled in yellow and, of course, UNDER the habitrail wire to give it some "lift and tilt"

Quoted from TxJay:

Yeah, mine doesn't hit the side wall.

IMG_8197.jpg

Thank you sir

Quoted from Buzz:

Mine has been fine.image.jpg

And thanks again

Quoted from Buzz:

My edge is flush to wall. Hope any of this helps.

...and again, thanks

Funny, I tried to adjust it a million ways. It just does not seem right BUT the spacer fixed it perfectly

2015-09-18 22.48.20.jpg

Promoted items from the Pinside Marketplace
7,500 (Firm)
Machine - For Sale
Santa Fe, NM
From: $ 40.00
Cabinet - Other
Rock Custom Pinball
$ 114.95
Cabinet - Shooter Rods
Super Skill Shot Shop
$ 44.00
Cabinet - Other
Pinball Forever
From: $ 20.00
Cabinet - Other
Rock Custom Pinball
$ 279.95
Lighting - Led
Pin Stadium Pinball LEDs

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside