Quoted from merccat:Any ol bearing will do apparently...
It's a power ball! 
(Topic ID: 28788)
You're currently viewing posts by Pinsider grumpy.
Click here to go back to viewing the entire thread.
2 weeks later
Quoted from algrande:Don't have a clue why this is there???
That's an isolation transformer that Canada required to be installed on imports from America. It just wastes electricity, remove and sell on Ebay.
1 month later
Quoted from j_m_:someone got up on the wrong side of the bed.
I hope this helps balance things a bit. 
2 weeks later
Quoted from uncivil_engineer:I saw this today on ebay.. someone put a lot of work into this.
I would buy this but he forgot to socket the oscillator, that's a deal breaker. 
1 month later
Quoted from Robotworkshop:Honestly I don't know what someone was/wasn't thinking as they hacked this board.
It looks like they were steeling parts from this board and didn't care about the damage they were causing.
Quoted from someotherguy:I'd say it could definitely be fixed, but "rainy day" for sure
I'm thinking a couple rainy days for sure.
1 year later
Quoted from pinballplusMN:Little guys are warm but wokrk! F 14 flash lamp board.
Actually if you do the math on these resistors, they are better then the originals.
3 months later
Quoted from JayDee:Nope. 60amps are even better. Little bit snug on the fit but they will never blow
[quoted image]
Now this is the fuse I use at work.
IMG_20191224_100510 (resized).jpg 3 weeks later
Quoted from Mad_Dog_Coin_Op:I’m trying to figure out what the game is. It isn’t a Party Zone.
Party Animal.
1 year later
Quoted from Pintopia:Found the problem see photos below....
What is the voltage rating on that yellow diode?
2 weeks later
1 year later
Quoted from Pintopia:Hmm… something looks suspicious…
[quoted image]
That there is "Magic Smoke" leaked out.
2 months later
Quoted from iamdrunker:Did they use a blow torch heat the shrink wrap?
I tried my best with what I have.
pasted_image (resized).png
You're currently viewing posts by Pinsider grumpy.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
