Hoping someone can help me out. I did a full tare down of my world cup and I have a metal piece left over and for the life of me I cant remember where it goes. Any ideas? Thanks for the help.

20180701_095503 (resized).jpg

20180701_095506 (resized).jpg

20180701_095509 (resized).jpg

20180701_095512 (resized).jpg

Yep. That's it. Thanks. I looked and looked but couldn't remember

I need help. I have adjusted cleaned and reposition the goal and vuk optos. They will work for a few goals. Then all of a sudden they go out or they get out of alignment. And I start getting free goals and the vuk will start to randomly go off. Any ideas. Is this common issue? Not sure if I need to replace them or what not. Thanks

Anyone have a used plastic laying around. I need the plastic that goes behind the goal and swings under the left ramp. Trying to avoid buying a whole set or paying a stupid amount on ebay. It's the one covered in white tape.

Screenshot_20181204-180703_eBay (resized).jpg

Thanks. That guy wants 110 shipped for that one and a few randoms. I can get the whole kit for under 200. Seems like that is the best way to go.

Replaced the end of stroke switch? Sometimes when they are dirty / bad you will lose power. Happened on my lah after southern fried last year. Had to replace one of them. Replaced it and I got my power back

Where can I find this code at?

I bought a set of plastics. While installing them I am having a hard time with the rivets. Is there a special or easy way to do them. I bought the ez sqeeze tool from Marco's and a assortment of rivets but it's a pita to do. Maybe I got the wrong size rivets. These are 1/8 dia. I can easily do pop rivets but they look horrible.

I bought the set from pps. They were good. I see sometimes. Marco's will mark stuff up. I always check other vendors before I buy from them.