I replaced the roll over buttons on my #PitStop, but I haven't been able to adjust them well - either they sit flush and don't trigger or they're way high and really disrupt the direction of ball roll. Is there a method to get it adjusted just right?

Thanks!

Screen Shot 2018-06-05 at 3.20.37 PM (resized).png

MikeO has it right, these are the PBR replacements with the nylon screw (there were mismatching a pretty trashed set prior).

I did compare the old with the new, but the old was also poorly adjusted and sending the ball careening in any direction.

I'll follow Stoomer's guidance and adjust both leafs, I'll report back here after..