Quoted from Gotfrogs:Troubleshooting with JJP identified that one of the drop target coils had burned up.
Bad coil and bad transistor driving it.
LTG : )
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Quoted from Gotfrogs:Troubleshooting with JJP identified that one of the drop target coils had burned up.
Bad coil and bad transistor driving it.
LTG : )
Quoted from LTG:bad transistor driving it.
Q421 IRL540 Page C-100 and Page D-123 in the manual.
LTG : )
Quoted from Gotfrogs:What does the coil in the picture I posted even do?
Knocks the drop target down.
Quoted from Gotfrogs:is there a way to test the Q421 IRL540 with the coil removed?
Yes. Check Youtube for short videos on how to test a transistor.
LTG : )
Quoted from irishpin:I have a 6 month old RR and the Winkie Target stays down all the time. What should I look for that would cause the target to stay down at all times?
Switch at the bottom of the mech is loose, fell off, or needs adjusting. So the game doesn't know if the drop target is up or down.
LTG : )
Quoted from Gotfrogs:I need to figure out why this is happening.
Not too much to it. Coil shoves it up, coil can knock it down. Be sure that switch is working properly so one of the coils doesn't continue to fire.
Then the transistor that drives it. Be sure it is soldered in good. And check continuity of each leg to a spot on the board away from where the legs are soldered to the board. Losing across or through board continuity can muck up the works. A weak, broken or cracked trace to one of the transistor legs can be hard to see and cause problems.
$80 a coil sounds excessive.
LTG : )
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/winkie-guard-coil-meltdown?tu=ltg and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.