Quoted from cal50:New male pin headers and connectors with trifurcon connectors properly crimped in place.
Sub some LED's for the GI for less current draw / heat or #44 ~ #47 bulbs.
The interconnect board could benefit the most from some TLC. I replaced all the cement resistors on my Whirlwind and left ample space off the board for better air flow and cooling.Look at the new resistors.JPG 3.7 MB
I am in the process of ordering new cement resistors for my High Speed. Please correct me if I am wrong, but are the eight resistors on right side of this picture wrong. I believe they are supposed to be "0.4 ohm" not "4 ohm", as in the picture in the above post. Please advice so I can order the correct ones.
Thanks