Suspense
Williams, 1969The ball that was in the game when I bought it is smaller and lighter than the 1 1/16" ball that the documentation says it should be. But the kicker that loads the ball to the shooter has a hard time getting the 1 1/16" up the ramp to load. Should I be using a smaller ball or start diagnosing the kicker that loads the ball? Pic of original ball attached.
Thanks
original ball (resized).jpegQuoted from ekm92:Should I be using a smaller ball or start diagnosing the kicker that loads the ball? Pic of original ball attached.
Kicker; Check sw. B on the Outhole relay and score motor sw 4C for cleanliness and solid contact.
That smaller ball looks like it belongs to ball roll tilt assembly at side of cabinet.
Check the switches as instructed, and clean the outhole kicker mechanism, maybe also replace coil sleeve. Make sure the kicker arm hits the ball in the middle, so it will not jump up and down when kicker operates.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/williams-suspense-ball-size?hl=tuukka and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Savannah, GA
Lempäälä