OP

Quoted from Nycon:

As you might be able to see the decal in the photo is mounted somewhat askew as well. I was a bit too lazy and did not remove the other VUK in front, or the big one, which would have made correct placing the decal much easier. I can place the decal on my large VUK (with the back on, so it is not sticking on immediately) well over the visible welding points. You might, however, end up with slightly different spacing between the outer side of the decal and the outer edge of the VUK, as there seem to be at least two versions out there, as I had to adjust the size down as two guys from the German forum reported that the decals were slightly too large for the metal parts they found in their machine. I visited on of them and took measurements. Hence I decided to ship out decals that fit on every machine without having to be cut for size-adjustment later on.

OP

Quoted from Nycon:

Sorry for being "off radar" for a week, but everything went a little haywire here. We had an unexpected death and a stomach cancer diagnosis in the family, both in one week. All in all that was a little bit too much and I had to prioritize, family first, always. I can only ask for your understanding in this situation.
Zitt's sets are almost completed and will either ship Monday. Same goes for jorro's.
The most recent posts on the German forum concern two people mentioning that the flipper bat decals are too large for the bats they have installed. This strikes me as odd, as all my machines have the same size bats (74mm / 2,91 inches).

OP

Quoted from Nycon:

It is nice to see that a silly saturday-afternoon-idea can find its way around the globe