The two 3" Flipper assemblies do not go with the game but the rest does.
(Topic ID: 169709)
Linked Games
Heat Wave
Williams, 1964
Topic Gallery
You're currently viewing posts by Pinsider em-pinman.
Click here to go back to viewing the entire thread.
They are the ones directly below the red flippers. The ones below that is the two playfield latches and below that the two locks that they go to the latches to lock them down.
Unfortunately my Heat Wave is a project and in storage but I will be able to get at it in a few days and get you the info. There may be someone else with one who can get you the info sooner if you are in a hurry.
1 week later
Tilt/Slam Switches.
1st pic: Right side Tilt Switch (Bottom Motor Board)- Open
Left Side Slam Switch next to Tilt Switch (unlabeled) - Closed
2nd Pic: Under Playfield Tilt Switch - Open
3rd Pic: Tilt Ball Switch (ball missing on mine) - Open
Tilt Bob - (Bob not touching sides) - Open
4th Pic: Coin Door Slam Switch - Closed
Notes: There is no slam or tilt switch in the back of the Head. All Tilt Switches are Open and all Slam Switches are Closed. Check to make sure wires are hooked up right and nothing is interfering with the switches. All switches shown is all the game came equipped with.
DSC00112 (resized).JPG
DSC00113 (resized).JPG
DSC00114 (resized).JPG
DSC00117 (resized).JPG
You're currently viewing posts by Pinsider em-pinman.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
