Hello everyone. I was just playing my Flash and the sound went out completely. I checked the fuses and they’re both good. I have -7.33VDC at 10J1 and at both ends of both fuses. Black lead on ground, red lead on the end of the fuse. Is that supposed to be negative voltage? The board was recapped a few days ago and all terminals on the connectors were replaced. It has been working well since, until now. The diagnostic button on the soundboard does nothing. There’s no hum at the speaker whatsoever. Turning the volume pot all the way up makes no difference. I’m going to take it out and give it a once over and see if I can find anything that stands out. Any specific places I should check? It all went out at once. No weird sounds, pops, or flashes. It just cut out. Thanks!