Still looking for myself.....
I already have the gold CPR playfield and plastic set ...... for security.
You're currently viewing posts by Pinsider shiny_balls.
Click here to go back to viewing the entire thread.
Still looking for myself.....
I already have the gold CPR playfield and plastic set ...... for security.
Hmmmmmm, I haven't been working on ramp lifting mechanism before....
Check the crank lock and lift crank assembly to see if any worn out.....
If nothing wrong, maybe move the crank lock or the bracket a bit? (fill the old holes with wood and glue)
Parts available at Marco.
Both my ramps are bad, like Chuck's on left and Megalo's on right. I'll move them to my new CPR playfield in few months. I'm currently doing a cabinet restoration.
Well, there are a few ways to adjust but you have to figure it out....
To move the Lock Plate.....drill out larger holes? (green markers) or cut and weld? (red lines)
Lift Crank Arm is too wide and hard to bend, maybe cut and weld? (blue lines)
If you screw up, you can get the replacement parts from Marco's
Note: There are extra thread holes on Armature Subassembly (A-8936) (yellow arrows) but maybe too much to move the Lock Plate? Just try it. If too much, maybe drill new holes and tap threads in the middle?
Good Luck!
Lift Crank Arm (resized).jpg
Quoted from chuckwurt:I need like a mm or two closer than that....
Thanks so much for the help.
Lock plate has about 75-85 degree angle, bend to lesser?
You're welcome!
Thanks.... yes, that's what I'm going to do!.... a tough metal rod with #4-40 thread on ends will go inside thin hollow braid cotton rope to avoid snapping.
Here's my backbox with nice wavy grain wood.....beautiful isn't it ?
Nice smooth semi gloss finish....just like the new kitchen cabinets!!
IMG_3023 (resized).JPG
Quoted from OLDPINGUY:Me too....definitely need some fire parts!
Hey OldPinGuy!
What kind of LED bulbs inside the buildings that dimmable?
.......or just use incandescent bulbs?
You're currently viewing posts by Pinsider shiny_balls.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/williams-fire-club?tu=shiny_balls and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.