Quoted from johnboy1313:I’ve been doing a lot of reading on the SRC6. If I’m not mistaken, the picture above has one too many 1k resistors in that hand built array. From what I’ve read and per the schematic, pin 10 is ground for the capacitors in the array. Folks are replacing with a 10 pin 9R SR (no C) and removing pin 10. I think the resistor array in the pic above shouldn’t have the last resistor at pin 10. Do any of you agree?
Correct, just snip off the last resistor. Also if you read 21 meg between pin 1 and pin 9, then resistor #8 has gone open and needs to be replaced. Strobe #8 will not work with a open resistor.