(Topic ID: 221368)

Whodunnit power driver board. What wires go where?

By Xanathar

3 years ago



Topic Stats

  • 5 posts
  • 4 Pinsiders participating
  • Latest reply 3 years ago by Xanathar
  • Topic is favorited by 1 Pinsider

You

Linked Games

Topic Gallery

View topic image gallery

IMG-1059 (resized).JPG
IMG-1056 (resized).JPG
IMG-1058 (resized).JPG
IMG-1057 (resized).JPG
IMG-1055 (resized).JPG

#1 3 years ago

I know this is probably such an idiot question but...

I removed my driver board and like an idiot didn't mark what wires go back to what connector. I can obviously figure out ribbon cable and the obvious ones, but I want to make sure I am plugging in all the wires back to their proper "J" locations.

Can someone possibly post a picture of their's or one that shows all the wires hooked up so I can have a visual reference?

Would be greatly appreciated

Thanks

#2 3 years ago

Check page 3-26 of the manual, it lists all the connectors on the driver board and the wire colors so you can match them up again

#3 3 years ago

Also, most of them are keyed so you can't plug them in incorrectly. Do still reference the manual to make sure, though.

#4 3 years ago

Hopefully these will help. If you need more info pm me.

IMG-1055 (resized).JPGIMG-1056 (resized).JPGIMG-1057 (resized).JPGIMG-1058 (resized).JPGIMG-1059 (resized).JPG
#5 3 years ago

This should help alot. Thanks for the repsonses

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside