Since there are normally 3 batteries in the remote holder at 1.5V per cell for 4.5V total, 4 batteries would be 6V.
So, you can just short one cell slot with a wire or other means and just use 3 of the slots (no battery in the 4th slot).
It might also be possible to just move one lead to a point where only 3 cell slots are used on the assembly and just ignore the 4th slot...
This is not quite as eloquent as having a battery holder with 3 slots, but at 65 cents....
You can decide what works for you...
You might also consider just forgetting about AA batteries and use a lithium flat 5V cell instead.
I think there are some mounts available that you can use to replace the 3 AA cell mount.
I see a lot of people doing that to avoid acid problems with AA batteries.
Then, you don't even need a remote battery holder.

You're currently viewing posts by Pinsider dent00.
Click here to go back to viewing the entire thread.

Reply

Wanna join the discussion? Please sign in to reply to this topic.

Hey there! Welcome to Pinside!

Donate to Pinside

Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!

This page was printed from https://pinside.com/pinball/forum/topic/who-sells-remote-battery-holder-kit-for-wpc?tu=dent00 and we tried optimising it for printing. Some page elements may have been deliberately hidden.

Scan the QR code on the left to jump to the URL this document was printed from.