Hey all, I just joined the club. I’m having a problem with the slot machine. The first and second real do not match what it says on the DMD screen. The third one matches every time. I have them in the correct order and all optos work. There is a little bit of wobble to all of them where it scrapes the Opto but they all spin properly. Could this be the problem?

When I hit the left outer loop, the diverter does not come up fast enough about 50% of the time. Any input why would be appreciated.

I wound up stripping the playfield on my who dunnit it and when I was finished I still had these two hex spacers. They are 1 1/4 inch long. Any ideas where they go?

image (resized).jpg

It’s not the spotlights

Thanks I think they’re from the upper playfield area.

This was happening because the switch in the outer left loop was flaky and did not register all the time.

My elevator ramp is a little cloudy but all intact. I stripped the playfield on mine and removed all the ramps and there was not any breaks or cracks. I was able to get all the slot reels working but they were wobbly so I replaced them all. The old ones would slightly scrape the opto slot at times. The new ones spin perfectly. If anybody gets the new reels, note that they do not come with the insert screw required to tighten them.

Ok, I don't recall where they came from but perhaps somebody was using them instead of a nut somewhere on top of a plastic so the ball didn't get stuck. They were definitely not for the spotlights or the ramps by the slings. Everything works as it should and I don't see them anywhere in the manual.