Recently joined the club and have been working through a few things on my game.

One question I have is the disaster drop hazard will only be awarded if shot from the left flipper. Is this how it is intended to work or an issue with opto sensor placement ?

Thx, I was hoping someone could confirm that before I get into checking out that opto. It looks buried deep under the upper playfield and difficult to get to.

Absolutely, in the next couple weeks actually. I got new ramps coming and will wait till then. Dont want to bother removing the upper pf twice, even if its easy, I got plenty of other games to keep me busy until then.

Figured this out and thiught I should post in case anybody else comes across the same problem. Second switch on ramp needed to be more sensitive. More about angle of approach specifically rather than which flipper.

From the right flipper the ball doesn't travel as fast through disaster drop and just rolls under the switch and it doesn't register.
From the left flipper it flies around disaster drop must faster because it hits the ramp dead centre and hits the switch and causes it to bounce up and register.

Looks the same as mine.

IMG_6088 (resized).JPG

Does anybody have a pic of the swicth and switch bracket on the rear of the bigfoot ramp. This is mine and it doesn't look to neat.

IMG_6510 (resized).JPG

Thank you

Ive been in touch with starship-fantasy.com and the repros are in the queue to get made again. Probably 2 months at least I was told.

Im running the home rom LH-6 and no, the locks do not lite and the big foot hot foot targets do not advance you towards big foot hot foot mode; although they make the same sounds as they do in non-whirlpool mode as though they do.

http://www.pinball.center/en/shop/pinball-parts-by-game/white-water/8752/boulder-garden-plastic-for-white-water?c=2082