Quoted from per3per3:
What’s up folks, I’ll be potentially joining the club in a week and had a few questions regarding LED installation on this machine:
1) Do you have to disassemble the upper playfield, whirlpool ramp, or anything else to install LEDs or are the bulbs otherwise accessible
2) Should I keep incandescents in the topper or do folks have suggestions on what to replace those with? Wasn’t sure if the overall effect is as good with LEDs vs. incandescents
3) Anyone use an LED kit from cointaker or pinballbulbs or have other LED recommendations?
Bally/Williams games most lights can be snagged from under the PF, which is super nice so always check that before disassembling. Disassembling nice at least because you can get a really good cleaning in. Wh20 looks bad but really isn't too difficult. Go slow, take lots of pics if you start to disassemble as well!!