I need help please! My big foot will not turn his head. The traces are all good on the board. The replaced the diodes. Still nothing. I just ordered a new cap for it but I don't think that will fix it. I can only get his head to move 1 way in the test mode. Then the error code will say head position unknown. Then I'm locked out. I have tried to wiggle wires no luck. Any thing else I can check?

I checked the switches on the board and they work. Well I'm saying they work they will open and close when I turn big foot in the test mode. Do you think the cap would be the fix? I don't think it will

I just replaced the transistors today and ordered the new cap. What chip in the board are you talking about? Sorry I not the best at this.

I couldn't test them with being in the circuit so I had to pull this out. They tested good but I had bought new ones so I changed them out. My soldier skills are good I had made sure nothing was touching. I powered it back on and everything was still the same. I need to buy a book for it..lol. I was being a tight ass! Now I'm paying for it. I will check the chip in the morning. I will try to reset it and see if it changes anything. Thank you for helping me out!

I have rebuilt the power board no difference his head still won't turn cw. What else can I look for? I will check the chip in the board today. Thank you for any help

Thank you very much! I found the problem
So if anyone has a problem with the big foot check the resistor @ R8. The head would only spin ccw. I hope this may help someone in the future! Thank you guys for the help!

20170325_111142 (resized).jpg

Pic was before I did anything to it. I wanted to show the problem. Board was cleaned and cap was replaced. Big foot is working great!

You are welcome! Next is the new side art! And my Addams family side art! Elvira is finished

20170325_223450 (resized).jpg