Getting ready to take on a big WW restore and joining the club. I am looking for the lift ramp for the right ramp. Part B-13233. I've searched but can't find any in stock. I'd need one with the rivets and hardware attached as pictured here: http://www.marcospecialties.com/pinball-parts/B-13233

Thanks for any help you can do

....Nevermind.

Went another direction

This might be a long shot but I'm looking for the diverter assembly. I am getting a WW that is missing that completely. Does anyone have a lead on one or maybe an extra? I've looked at the usual shops but can only find the plunger for it. I would need the diverter arm and entire coil bracket.

Thanks

Thanks, found one!

I'm looking to purchase the ribbon cables for Whirlwind. Can someone confirm that it takes 3 ribbon cables? Are they two 20 pin and one 26 pin? Can you also tell me how long each ribbon cable is?

I've looked on Marco's site and the part numbers don't match up with the manual.

Thanks for your help here.

Ok, figured out the ribbon cables. They are 20 pin (9 and 12 inch) and 26 pin 27 inch.

I'm needing a little help with a connector. I'm not sure where the bottom half of this harness plugs into. This one goes to the SOL audio board and to the triac board.

The bottom is a flat inline molex 5 pin connector and also a single molex terminal. I'm assuming this goes under the playfield but I can't find where.

The bottom that I can't figure out:
IMG_1411 (resized).jpg

The top:
IMG_1412 (resized).jpg

I found that I had two of the same harnesses in my machine. After searching for the connectors in the above pictures, I found one already connected. Weird

This made me laugh.

Agreed

I'm putting my ww together which was missing the big ramp. I'm needing to find the little mounting piece that goes on the wood rail that attaches to the metal outhole from the exit of the ramp. It is circled in the following pic. Anyone know where to source one of these?

whirlwind bracket pic (resized).jpg

I'm just about finished with my restore. The last thing I'm missing is the diverter. The coil and bracket is all there, I just need the diverter that goes up through to the ramp.

I was hoping someone can help me locate one. I have searched the usual online stores but I'm holding out hope there's one out there. Thanks.

Can someone tell me the size of the post circled in red? I'm having a hard time finding it. Thanks.

whirlwind post (resized).jpg

Ok, thanks but the bumper post I have in that spot has a 6-32 top on it and those hex spacers are 8-32. Do I have the wrong bumper post in there?

Thank you very much for the picture.

You said the bottom post has a 6-32 top. Isn't that hex post 8-32? I'm a bit confused by that (but that's nothing new for me).

Thanks sohchx, that's what I couldn't find.

Anyone need a replacement lift ramp? I bought one and never installed it. Don't have the machine anymore. This is the full lift ramp but does not come with the hinge.

Edit: Sold!

Message me if interested

Torin