Quoted from krahsdnal:

I am looking for the circuit board on the back of the "door" on the back box. Mine has shorted out only about 1/2 the lights on the back board lightup. Most places on the net that I have found are sold out.
SY11-RB1-A
System 11 24V Solenoid and GI Relay Board
Cross-Reference
OEM P/N # C-11998
PCB # 5768-12243-00
Any help would be appreciated.[quoted image]

Quoted from yaksplat:

Can someone tell me what the dimension in the gap on their lift ramp looks like? I have my original version and the version from Starship Fantasy.
My original is on the left and the one from starship on the right Part number 02-4429, pin crank is sitting in the gap. In the original, it's loose and in the new ramp the pin won't move. Larry says, "The pin in your game is not the original."

Quoted from yaksplat:

Trying to find the other end of these two connectors in the backbox. The violet, white/violet is off the lamp harness.
Does the black/black-yellow go to the speakers?[quoted image][quoted image]

Quoted from yaksplat:

Thanks. Any idea about the violet - violet/white one? It's right near the 18 pin connector @ j14 on the interconnect board.

Quoted from Initiative:

while i have everyone's attention here does anyone have any advice on the best way to pull out and prop up a system 11 playfield from the cabinet without undoing/disconnecting the umbilical cord? I need to replace the left ramp on this thing and it seems the only way to get to the mounting hardware in the back is to get the playfield out of the cabinet.... feel free to tell me im being dumb and there's a batter way

Quoted from wrd1972_PinDoc:

Hey guys the disks are not spinning on my Whirlwind. Cant find references to that motor in the SM.
Any ideas?

Quoted from mark532011:

Hey guys, my Whirlwind is on the container ship from Italy right now.

Quoted from Jmckune:

https://www.pinballinc.com/index.php?route=product/product&product_id=98

Quoted from DANGERTERROR:

I have a Whirlwind on location having a weird issue.
It gives one regular bong on boot up, but never goes into attract mode. Loud feedback hum.
I poked around a bit but it suddenly worked perfectly and I never figured out what presumably chip or connector was the issue. It’s humming and not fully booting again a few days later. Any ideas? The feedback hum is super weird!

Quoted from DANGERTERROR:

Switching it in and off does nothing to change it’s hang up. Also see a garbled screen sometimes.
Then… it just works. For hours at a time.
Reseated ROMs on MPU and connectors, no effect. Getting 5V at MPU, LED indicates that, but diagnostic led flashes endlessly when the game decides not to boot.